Product introduction
The Yazhou PQDN stainless steel submersible pump has a built-in stainless steel structure and uses a single-phase power supply. It features a compact size and attractive appearance, and is suitable for garden irrigation and small-volume water drainage.
Instructions for use
- Startup
- · Before starting, check whether the water pump installation and power connection are correct.
- · The float switch is connected directly to the pump to control its start and stop. Check that the float switch can move freely without interference from other objects.
- · For water pumps without a float switch structure, the pump starts when it is completely immersed in water. If the motor is not completely immersed or runs for too long in water above 40°C, the motor will stop. When the motor coil temperature is too low, the thermal protection device automatically switches on.
- · Start the water pump, let it run for a few seconds, and check its startup, operation and rotation direction (for three-phase pumps, if a wrong rotation direction is found, swap two phases and then start again); if little or no water flows out, it indicates a rotation direction fault of the water pump, and the phases should be swapped.
- Operation
- · When the pump is running, attention must be paid to the water surface level (especially when operating at small capacity); once the water level is insufficient, the pump must not be allowed to run. If the water pump runs for a long time without water, the motor or coil will burn out.
- · The actual lifting height (from the water surface to the destination) should not be less than 80% of the specified lifting height (see the nameplate for lifting height).
- · The voltage fluctuation should be within 10% of the rated voltage, otherwise the motor life will be shortened or the motor may even be damaged.
- · When the water pump is running, if abnormal phenomena are found, such as unusual noise, little or no water output, immediately cut off the power and stop the pump. Do not touch the pump body when it is energized or wet.
Performance parameters
| No. |
Model |
Flow
(m³/h)
|
Head
(m)
|
Pipe inner diameter
(mm)
|
Use voltage
(V)
|
Package size
(cm)
|
Gross weight (kg) |
| 1 |
Stainless steel single-phase electric pump |
PQDN1.5-4.5-0.08KW |
1.5 |
4.5 |
25 |
220 |
12×12×30.5 |
4 |
| 2 |
PQDN3-5-0.12KW |
3 |
5 |
25 |
220 |
14×14×32 |
5.5 |
| 3 |
PQDN1.5-7-0.12KW |
1.5 |
7 |
25 |
220 |
14×14×32 |
5.5 |
| 4 |
PQDN5-7-0.25KW |
5 |
7 |
40 |
220 |
16×16×36 |
7.5 |
| 5 |
PQDN3-25-0.55KW* |
3 |
25 |
50 |
220 |
21×21×45 |
13.5 |
| 6 |
PQDN1.5-30-0.55KW* |
1.5 |
30 |
50 |
220 |
15×15×52 |
16 |
| 7 |
PQDN6-14-0.55KW |
6 |
14 |
40 |
220 |
19×19×37 |
9.5 |
| 8 |
PQDN10-10-0.75KW |
10 |
10 |
50 |
220 |
19×19×37 |
12 |
| 9 |
PQDN25-6-0.75KW |
25 |
6 |
65 |
220 |
19×19×47 |
12.5 |
| 10 |
PQDN3-30-0.75KW* |
3 |
30 |
50 |
220 |
21×21×45 |
15.3 |
| 11 |
PQDN1.5-40-0.75KW* |
1.5 |
40 |
50 |
220 |
15×15×56 |
17 |
| 12 |
PQDN3-35-1.1KW* |
3 |
35 |
50 |
220 |
21×21×47 |
17 |
| 13 |
PQDN6-24-1.1KW* |
6 |
24 |
50 |
220 |
21×21×47 |
17 |
| 14 |
PQDN8-20-1.1KW* |
8 |
20 |
50 |
220 |
21×21×47 |
17 |
| 15 |
PQDN1.5-60-1.1KW* |
1.5 |
60 |
50 |
220 |
15×15×63 |
19 |
| 16 |
PQDN1.5-80-1.5KW* |
1.5 |
80 |
50 |
220 |
15×15×70 |
22 |
| 17 |
PQDN6-30-1.5KW |
6 |
30 |
50 |
220 |
21*21*49 |
16 |