Shanghai Yazhou Pump Manufacturing Co., Ltd. · Professional Pump Manufacturer Hotline: 021-57775777 Mobile: 15921707645 Email: 34305982@qq.com
Home / Product Center / OIL PUMP / 2CY Gear Oil Pump

2CY Gear Oil Pump

OIL PUMP

The 2CY series gear lubrication oil pumps and gear oil transfer pumps from Asia Pump Industry are primarily used for transporting lubrication oil in the lubrication systems of various mechanical equipment.

Product Introduction

Product introduction

The 2CY series gear lubrication oil pumps and gear oil transfer pumps from Asia Pump Industry are primarily used for transporting lubrication oil in the lubrication systems of various mechanical equipment.

Applicable range

  • Suitable for conveying various lubricating liquids with a temperature not higher than 300°C; if a high temperature of 200°C is required, contact Yazhou Pump to equip high-temperature-resistant materials. The viscosity is 5×10⁻⁶ to 1.5×10⁻³ m²/s (5–1500 cSt). Not suitable for conveying corrosive liquids, liquids containing hard particles or fibers, highly volatile or low-flash-point liquids such as gasoline and benzene. In addition to a standard motor, an explosion-proof motor of the same specification can be equipped according to user needs.

Instructions for use

  • · Before starting, check whether the pump shaft rotates flexibly without jamming, whether the valves on the inlet and outlet pipelines are open, and whether the pump rotation direction is correct.
  • · For a pump that has not been used for a long time, inject a certain amount of lubricating liquid into the pump chamber before starting to reduce dry friction during oil suction and improve the self-priming performance.
  • · If abnormal noise or overheating occurs after starting, stop immediately for inspection.
  • · Check whether there is leakage at the pump shaft end; for packing seals, the gland should be appropriately tightened, while other seals require disassembly for inspection.
  • · If conveying hot oil, preheat evenly at startup; preheating is carried out by continuously passing the conveyed medium through the pump body.
  • · Preheating standard: the oil temperature at the suction inlet should not be more than 40°C higher than the pump body temperature; the preheating rate should be controlled below 40°C per hour. During preheating, loosen the bolts fixing the pump body; after preheating is complete, tighten them.
  • During preheating, pay attention to observing the pump operation; once any unfavorable phenomenon is found, stop the pump immediately for inspection.
  • · When stopping the gear oil pump, first cut off the power, then close the valves on the inlet and outlet pipelines to avoid reverse rotation of the pump.
  • · After long-term use, if the pressure and flow drop significantly, disassemble the pump for inspection and replace the worn parts.

Product Gallery

Related Products